Astm D3654 Pdf

The following editions for this book are also available

Historical Version s - view previous versions of standard. Remember me for one month.

Telecommunications Industry Association. Astandard mass is attached to the free end of the tape andallowed to act for the specified time. The resulting means and con?

Society of Allied Weight Engineers, Inc. Thepanel is mounted vertically, a standard mass is attached to thefree end of the tape and the time to failure determined. International Electrotechnical Commission. If you like to setup a quick demo, let us know at support madcad.

This standard is not included in any packages. Synapse Information Resources, Inc. British Standards Institution. Test specimens should be taken from several rolls of a tape and, whenever possible, among several production runs of a tape.

ASTM D Standard Shear Adhesion Tester for Pressure Sensitive TapesASTM D3654/D3654M 06(2011)

Deutsches Institut fur Normung E. There is no abstract currently available for this document.

Description of ASTM-D3654 2002

ASTM D - D M - 06

This standard is subject to revision at any time by the responsible technical committee and must be reviewed every? Proceed to Checkout Continue Shopping. Obtain the arithmetic mean of all logarithms and then convert back to time by obtaining the appropriate antilogarithm. For Procedures A and H, substitute steel panel instead of?

International Organization for Standardization. Take care in the choice of samples and when comparing results between fiberboard surfaces which may not be exactly the same. Combiningvalues from the two systems will result in non-conformancewith the standard. American Welding Society, Inc. To be suitable, materials must be lint freeduring use, absorbent, sarna sarcoptica en perros pdf contain no additives that a.

ASTM D Standard Test Method for Holding Power of Pressure-Sensitive Tapes

Theassessment may be within a roll of tape, between rolls orproduction lots. The panel ismounted horizontally, tape side up, with the free end of the tapeallowed to hang vertically over the round end of the panel. Northern Marianas Islands. Procedures E, F, and G may be used to determine the ability of a filament reinforced tape to hold when placed under constant stress.

Please first log in with a verified email before subscribing to alerts. Technology International, Inc. Aerospace Industries Association.

Prices subject to change without notice. By navigating on this website, you accept their use. Search book title Enter keywords for book title search.

The panel is mounted horizontally, tapeside up, with the free end of the tape allowed to hang verticallyover the rounded end. Panels showingstains, discolorations, or numerous scratches are not accept-able. Construction Specifications Institute, Inc.

American Petroleum Institute. Other grades may be used, provided it is firstascertained the reagent is of sufficiently high purity to permitits use without lessening the accuracy of the determination. It is theresponsibility of the user of this standard to establish appro-priate safety and health practices and determine the applica-bility of regulatory limitations prior to use.

This test method describes procedures for determining the ability of pressure-sensitive tapes to remain adhered under constant load applied parallel to the surface of the tape and substrate. Link to Active This link will always route to the current Active version of the standard. World Scientific Publishing Co.

Combining values from the two systems will result in non-conformance with the standard. During storage, panels should be protected from damage or contamination.

This may be used to compare the shear adhesion of a tape to a particular fiberboard surface or to compare the shear adhesion of a tape to a variety of fiberboard surfaces. The assessment may be within a roll of tape, between rolls or production lots. Codes and Standards Training, Inc. Addison-Wesley Publishing Co. Copyright Compu-tecture, Inc.

ASTM D3654/D3654M 06(2011)